How To Remove Adhesive From Keel Guard
How To Remove Adhesive From Keel Guard. Etch or scuff the keel surface, taking. The heat gun will heat up the adhesive and make it much more pliable.
My wife and i started removing our old keel guard this morning and got the actual keel guard off and with the help of a heat gun and plastic scrapper, we got the gray foam membrane off. Before applying the keel guard, the fiberglass mold release agents must be removed by etching or scuffing the surface. Wd40 lubricant, scrape the thicker part of the adhesive off.
I Installed A Keel Guard Last Year And It Is Starting To Come Off In The Middle In A Small Area.
While tough, keel guard is also very pliable to conform to the shape of any boat keel. 3m 5200 is the only thing i've seen work with decent results. Yes the better your prep and install the harder to remove the 3m tape adhesive.
The Last 1' Or So Is Hanging Off The Boat.
Mw marine quoted $525 to remove the old and install the new. There is an awesome thread going of the riverwhips fb page right now, regarding how to remove an old keel gaurd. Make sure you are outside and well ventilated.
Chris Reed Showing How To Remove A Worn Keeleazy Strip.
The keel protector keeps you from destroying your gelcoat, so when the keel protector fails (and many do), then you get to destroy the whole area underneath it while removing the glue and then replace the now compromised glass with another one and repeat. If already peeling back then removal of the guard sounds easy enough. Wd40 lubricant, scrape the thicker part of the adhesive off.
In The Unlikely Event You Need To Remove A Megaware Keelguard®, It Can Be Done.
The 3m® adhesive is designed to shear apart if enough strength and energy is exerted. Easy keel guard adhesive removal boats. Be sure to get rid of all the old grey adhesive foam and flatten before applying (would be my suggestion), then duct tape or similar to hold in place.
Once I Got The Actual Keel Guard Off, There Was Alot Of Leftover Glue/Adhesive On The Hull.
Depending on where you live, this isn't the time of year to be trying to work with adhesives unless you have a heated area that you can keep the boat in at 70*f. I used a heat gun to soften it with a plastic scraper. The heat gun will heat up the adhesive and make it much more pliable.
Post a Comment for "How To Remove Adhesive From Keel Guard"